Jason Hartschuh, Extension Field Specialist, Dairy Management and Precision Livestock, The Ohio State University
Spring weather has created many planting challenges, with some regions of the State being able to finish planting by the end of April, while others are still trying to finish planting in early June. Early planted corn has already experienced many stressors due to cool wet weather after planting.
Scouting each cornfield as it begins to tassel and assessing weather conditions are important parts of making fungicide decisions on your farm. The crop protection network, which The Ohio State University is part of, offers a tool at https://connect.doit.wisc.edu/cpn-risk-tool/ that can be used to determine if environmental conditions are right for tar spot, gray leaf spot development, and Gibberella ear rot/DON.
When fungal disease is present in silage corn at tassel, a fungicide application at VT-R1 to control these fungal diseases reduces fiber (neutral detergent fiber, NDF) concentration and improves the nutritional value compared to the untreated control. Corn treated with fungicide had improved fermentation and more consistent dry matter values. When fungal disease infects corn, one of its natural responses to stop the spread of the disease is to increase lignin around the infected area to stop the spread of the disease, which reduces plant digestibility.
Tar spot was first reported in Ohio in 2021, with only very late-season reports in 2022; however, by 2023, a few areas of Ohio found tar spot at tassel. Research has shown that corn planted later is at the greatest risk of tar spot losses. One of the greatest risks to corn silage is from severe infection, causing premature plant death. Tar spot reduces silage moisture, digestibility, and energy, which can also lead to poor fermentation with lower silage moisture and plant sugars. Scouting for tar spot should be done weekly from tassel through R3. Lesions will be small, black, raised spots appearing on both sides of the leaves along with leaf sheaths and husks. If tar spot is found in fields, a fungicide application can help slow disease spread but be cautious of the preharvest interval of applying the fungicide.
Other leaf diseases, such as gray leaf spot, northern corn leaf blight, common rust, and southern rust, can also decrease plant digestibility and fermentation just not as rapidly as tar spot. Identifying the diseases present in your field can help you choose the most effective fungicide when it is needed. Once the diseases in your field are determined, use the Fungicide Efficacy for Control of Corn Disease chart to select the best fungicide for your needs: https://cropprotectionnetwork.org/publications/fungicide-efficacy-for-control-of-corn-diseases. This chart can help you determine both efficacy and harvest restrictions.
Maybe the biggest concern for dairy producers is mycotoxin contamination of corn silage and high-moisture corn. Your goal should be to have silage below 1 ppm deoxynivalenol (DON) to utilize in your lactating ration. Fungicides may reduce mycotoxin levels.
Deoxynivalenol and Zearalenone produced by the fungus Fusarium graminearum are two of the primary mycotoxins in Ohio corn. Fusarium graminearum causes both Gibberella stalk rot and Gibberella ear rot, making it of concern for quality in both the grain and forage. One study under low Gibberella disease pressure revealed that in all cases but one, an application of fungicide at R1 reduced DON levels by at least 50%. The trial was then expanded the second year, which was a high disease pressure year with DON levels as high as 17.9 ppm in one hybrid and 30.3 ppm in the other hybrid. Again, fungicide had little effect on the yield or forage quality of these two brown midrib (BMR) hybrids, but a few products consistently lowered DON levels.
A 2021 corn silage trial in Ohio demonstrated a reduction in vomitoxin from 3.1 ppm in the control to 0.5 ppm with the application of Miravis Neo. The products that consistently lowered DON levels contained a triazole as one of their active ingredients, with prothioconazole being the most common. Historically, only Proline and Miravis Neo are labeled for stalk and ear rot control. This winter, two product combinations received 2ee labels for the suppression of Fumarium and Gibberella ear root. The first combination is Prosaro® PRO 400 SC Fungicide + Proline® 480 SC Fungicide, while the second combination is Delaro® Complete + Proline® 480 SC Fungicide. The ideal application window is R1, which spans from the point when silks emerge until they become brown and dry (R2), approximately 10 days later. If weather conditions do not look favorable for a fungicide application in this window, it is better to apply the fungicide after tassel emergence, even if silks are not present, than after the silks are brown and dry. For the fungicide to move inside the husks to protect the grain, the silk channels must still be active. This application timing is primarily for Gibberella ear rot, which infects the ears during pollination. This creates some logistical issues for applications that require high-clearance sprayers or aerial applications. We have observed better coverage at the silk level when using 20 gallons per acre compared to 15 gallons per acre with a high clearance sprayer, but so far, we have not seen a difference in disease control. We are currently studying best practices when using a drone application. Mycotoxin levels were low in the past two years, so no differences were observed. For foliar disease control, all drone applications decreased disease severity. However, we observed a statistically significant increase in grain yield when using 5 gallons per acre with the drone, compared with 2.5 gallons per acre. Using the highest practical application rate per acre improves coverage and disease control. Scouting corn for disease from emergence through brown silk is one tool to help maintain feed quality.